There are many innovations introduced by AMS (Aerospace Material Specifications) 2750 revision F concerning the process instrumentation.

We will analyze the 4 new requirements requested by the legislation and the necessary precautions regarding the instrumentation calibration.

We will conclude by listing in detail all the information to be reported on the instrument calibration certificates.

Leer todo el artículo...

Revision F of the AMS (Aerospace Material Specifications) 2750 introduces three important changes concerning the equipment of the instrumentation of the heat treatment furnaces.

Which are the changes to the uniformity requirements required by the technical specifications of the process and by the technical specifications of the material?
How are the types of instrumentation of heat treatment plants classified?
And finally, what is the new D+ instrumentation type?

Leer todo el artículo...

Revision F of the AMS (Aerospace Material Specifications) 2750 introduces many new features, in particular there are limitations on the alternate SAT and some conditions in which it is necessary to replace it with the comparative SAT.

What is the comparative SAT?
What are the operational procedures of the comparative SAT?
Is it possible to effectively measure the maintenance of the qualification performance of our plant and consequently the operational continuity?

Leer todo el artículo...

AMS 2750 (Aerospace Material Specifications) is an aerospace international specification which covers the pyrometric requirements for plants used for the heat treatment of metallic materials. Specifically, it covers temperature sensors, instrumentation, plant equipment, correction factors and offsets of instruments, system accuracy testing and temperature uniformity testing. These are necessary to ensure heat treatment of parts or raw materials in accordance with applicable specifications.

The AMS 2750 is now in revision F, was revision E from July 2012.

Let's see what’s new.

Leer todo el artículo...

In the previous article we’ve seen how AlTiN thin film deposition process was carried out via reactive Physical Vapor Deposition High-Power Impulse Magnetron Sputtering (PVD HiPIMS) to coat Ti6Al4V substrates, realized via Selective Laser Melting (SLM).
Two different SLM process conditions were employed for modifying the obtained part surface morphology and, later, the samples were heat-treated under high vacuum.

Do not miss this in-depth investigation and the conclusions at the end, we’ll provide you all the information to get the most out of these three technologies.

Leer todo el artículo...